03-27-2025, 11:27 PM
(03-24-2025, 11:34 PM)polfi67 Wrote: To be safe, I did a clean install. The attached video was made after the installation. I select the two files and press F3. Notepad++ starts, but only one of the files loads. When I copy an image and repeat the operation, it appears that even though the two bat files are selected, the image view is displayed and not Notepad++.
My question is what and where should I set it to make opening two files at the same time work.
Thanks
Thank you for your report.
TC UP Opener let you open more then 1 file at once. However, you have to know that it should be files with the same extension.
So, selecting 2 files with the same extension should work fine. But if you select one file with .bat extension and other with .jpg extension this two files will be opened in application associated with first selected file (here, our bat file). If first selected file is jpg it will be opened in XnView (bat file is not supported in xnview...).
I checked it in my installation and everything works - 2 bat files are opened in notepad++.
Ps: I do not see any selection on your video... Are you sure you select both files?
-Pawel